TinyCAD Manual
tinycad.net

8. Measuring amplifier gain and bandwidth

Previous · Contents · Next

The examples in this chapter are bundled with TinyCAD. Choose Open Example → SPICE tutorial, select the named example, then choose Open Drawing. No download is needed.

Open amp-ac. It is the rebuilt amplifier with AC amplitude 1 on VIN and an AC sweep from 1 Hz to 100 MHz at 60 points per decade. The wide upper range makes the generic transistor model’s roll-off visible; it does not establish that the original hardware behaves accurately at RF.

Select Voltage gain, the saved OUT/IN derived trace. View magnitude in dB and phase. Keep node voltages and dimensionless gain distinct in your notes.

Computed amplifier gain and phase

Read the result before explaining it

With RL = 8 Ω and R6’s electrical split at 0.5, the reference gain at 1 kHz is about 0.892 V/V, or −0.995 dB, with approximately inverted phase. The sampled peak magnitude is also about 0.892. Half-power crossings relative to that peak lie near 24 Hz and 2.9 MHz; these rounded values reflect the sampled sweep and the chosen generic model.

These are not unity-gain crossings. A −3 dB bandwidth is measured relative to the amplifier’s passband or peak gain, not necessarily relative to 1 V/V. In TinyCAD’s named bandwidth measurement, select OUT and IN, and set the reference gain to peak when investigating this band-pass-shaped response. A bandwidth measurement needs both crossings inside the acquired frequency range.

Why the overall voltage gain is below one

VIN is measured before the volume potentiometer. Its wiper voltage is reduced further by the amplifier’s finite input impedance. Q1 then provides an inverting voltage gain. Q2 drives a very heavy 8 Ω load through C2, and its finite output impedance causes additional attenuation. The overall ratio includes every stage.

Compare BASE/IN, COLLECTOR/BASE and OUT/COLLECTOR as separate derived ratios. They answer different questions. A stage can provide voltage gain while the complete input-to-load path has less than unity gain. An emitter follower can still provide useful current gain even when its voltage gain is below one.

Find the causes of the low- and high-frequency limits

C1 and C2 are series coupling capacitors. Their reactance increases at low frequency, so they attenuate the signal. C2’s effective resistance includes both the load and the stage’s output impedance; using only 1/(2π × 8 Ω × C2) does not fully describe the loaded circuit. At high frequency, transistor capacitances and transit time in the model reduce response and change phase.

Try the following controlled changes, restoring the original after each:

  1. Change RL from 8 Ω to 80 Ω. Compare passband gain and the lower corner.
  2. Double C2. Check whether the lower corner shifts as much as expected if C2 dominates; C1 and loading may also matter.
  3. Change R6’s electrical split. Record the gain from IN and the gain from BASE separately so volume attenuation is not confused with transistor-stage gain.
  4. Increase points per decade near a crossing and check that the reported corner has stabilised before quoting more digits.

AC analysis predicts response to a sufficiently small perturbation around the bias point. It does not limit output amplitude to the available supply swing. The next chapter uses a finite transient input to find where the small-signal prediction stops describing the actual waveform.

Download the lesson circuits

The same examples are already available in Open Example. For an independent copy, download a .dzn drawing and use File → Open in TinyCAD. The .cir companion is SPICE text for inspection or a compatible external simulator, not a TinyCAD drawing. XSPICE circuits require Desktop for fresh runs.

Example Drawing Netlist
amp-ac TinyCAD drawing SPICE text