TinyCAD Manual
tinycad.net

Touch Controls

On a touchscreen, you can edit the drawing directly or use the loupe for more precise placement. These controls work in the browser and desktop editor.

Direct touch

  • Tap to select or place an object with the active tool.
  • Drag with one finger to move objects or make a selection, as with the mouse.
  • Hold a finger still for about a second to open the drawing context menu.
  • Move two fingers together to pan the drawing; pinch them apart or together to zoom the canvas around the gesture.
  • Drag a symbol preview from the library panel onto the drawing to place it.

Auto-route wires with two taps

Use Point-to-Point Wire in the toolbar to connect two pins, or a pin and an existing wire, without placing each corner. Tap the starting connection point, then tap the destination. TinyCAD chooses the route and places the wire segments. This is useful with a mouse too, but particularly helpful on a touchscreen because it reduces the number of precise placements.

If the endpoints are small or crowded, use the loupe’s Click control at each endpoint instead of tapping the pins directly. See auto-routing wires for the full procedure and an example.

Precise placement with the loupe

The loupe magnifies the area around an aiming crosshair, so your finger does not cover the connection point you are trying to reach.

  1. Tap the drawing if necessary to reveal Show Loupe, then tap that button at the bottom of the drawing.
  2. Slide one finger across the canvas to aim the crosshair. Movement is slower than your finger for finer control; lifting your finger leaves the aim in place.
  3. Use the labeled controls below the lens:

    Control Action
    Click Click at the crosshair to select an object or place a point with the active tool.
    Drag Begin dragging at the crosshair. Slide a finger across the canvas to move the pointer.
    Drop Finish the drag. This replaces Drag while a drag is active.
    Menu Open the context menu at the crosshair.
    Close Close the loupe and return to direct touch.
  4. Tap Hide Loupe to return to direct touch.

Touch loupe showing a magnified connection area, crosshair, and Click, Drag and Menu controls.

For example, to draw a wire, choose Wire, aim at the starting pin, and tap Click. Slide your finger to aim at the next point and tap Click again. Use Menu for the tool’s context commands when you want to finish or cancel.

Two-finger pan and pinch zoom also work with the loupe open. Finish an active drag with Drop before changing the view.